Wurlitzer 200 / 200A

Experimental installation — current scope

Installation status

Installing MIDIfy in a Wurlitzer is currently experimental. There is no fully established installation solution yet, and the final mainboard mounting position has not been determined.

Connections and installer decisions

The installer must determine the position and arrangement of the external connections. No complete mounting solution for these connections is provided, as the implementation depends on the individual instrument.

The mainboard connects to the Breakout board through an FPC cable. Generic Board and Breakout board refer to the same board. It has solder pads for connections such as power, potentiometers and an expression pedal. The installer decides which connections are needed and wires them accordingly.

No specific Wurlitzer sustain-pedal installation has been established yet. The sustain sensorboard and its magnet are included in the test kit. At this stage, the installer must determine how to mount and connect them.

Installation chapters

Follow the hardware installation guide, then continue with startup and calibration in the MIDIfy WebUI.