Preparation

Check the condition of your Rhodes

Before installing MIDIfy, make sure your Rhodes is in good mechanical condition and properly regulated. The keyboard must be level, and the key frame must sit flush in the case and be securely fastened.

Key dip should be between 9.5 and 10 mm.

Complete any necessary repairs or regulation before starting the installation.

Undo the name rail screws

Using a Phillips screwdriver, remove the four screws securing the name rail: two on the left and two on the right. Keep the screws for reassembly.

Remove the name rail

Disconnect the RCA cable, then lift out the name rail and set it aside.

Undo the key frame screws

Remove all screws securing the key frame from the underside of the case. The number of screws varies depending on the year of manufacture. Keep the screws for reassembly.

Lift out the key frame

Lift the key frame out of the case.